As part of addressing ever growing and ever changing requirements of energy metering, EMCO has set-up an extensive research and development centre. This R&D centre maintains EMCO’s leadership in the electricity metering market by focusing on deployment of latest technologies and customized offering to various customers. This R&D centre is fully equipped, which apart from having a team of dedicated technologist in the area of electronic hardware, real-time embedded system, communication systems, applications software, mechanical design and reliability engineering also has a complete test set-up required for type validation of an energy meter. EMCO has developed unique solutions in the area of tamper detection, load management, revenue protection, energy accounting and communication.
 |
|
EMCOSINE Active Harmonic Filter
EMCO active harmonic filters, correct anomalies and deliver clean sinewave power output which reduces strain on equipment, increasing longevity, safety and reliability of critical electrical equipment.
Applications
Oil, gas & petrochemicals
Automotive
Pharmaceuticals
Cement
Pulp & Paper
Water & Water treatment industry
Textile industries
Steel rolling mills
Plastic extrusion
IT/ITES
Shopping Malls
Banks & data centers
Hospitals
Hotels
Food & beverages.
Features
Employs DSP & IGBT technology.
Fast dynamic response
Suppresses Harmonic currents
Wide product range; 25-200A
User friendly control panels
Easy to install and operate
Negligible maintenance
Complies to IEEE 519-1992 standards.
Advantages
Reduces the harmonic current thereby increasing the loadability of lines.
Saves energy
Increases equipment life
Improves power quality
Avoids unwanted interrupts by controlling harmonic pollution in the system
Protects from overloading and overheating of cables and transformers.
Prevents failure of sensitive equipments.
|
 |
|
Automatic Power Factor Correction System
EMCO understands that commercial and industrial power consumers typically seek to control power factor deviations in order to achieve more efficient utilization of purchased electrical energy. To address this latent demand for efficient, reliable means to manage energy utilisation, EMCO presents an automatic factor correction system.
In any supply and distribution system, losses will occur as part of the normal transmission of electrical power through the system. A relatively poor power factor is typically generated by a significant phase difference between the voltage waveform and the current waveform at the load. These are typically found higher in industrial and commercial facilities.
As a matter of efficiency and cost-savings, the improvement of power factor close to unity levels, represents not only a more efficient utilization of power but a reduced cost of operation. EMCO power factor correction system uses intelligent switching of capacitors to stabilize power output
Features
APFC unit has a real time 8 bit controller, 32 kHz for reliable stand alone operation, signal processing.
64KB Flash for Stack store, 512kb EEPROM onboard to store Data & 2KB RAM in built memory.
Inbuilt Two RS232 port for GPRS, CDMA & Modbus communication.
Auto/manual Control contact which can operate Capacitor Banks.
Capacitor Banks are expandable as per user requirement.
Over current protection through MCBs/Fuses.
Real Time controller has a very stable inbuilt clock with a battery backup.
Option with integrated metering and AMR.
Advantages
Advantage of Implementing APFC system to utility & Consumer:
Single Solution for metering, AMR and power factor correction
Reduces operation & administration cost.
Energy auditing (DT Meter).
Improves Power Factor leading to reduction in Energy losses.
Reduction in consumer complaint.
|
